C Sort Flex-Flex Couplings
The C Type coupling includes two flex hubs, one sleeve and a single accessory kit consisting of seals and snap rings.
CFR Kind Flex-Rigid Couplings
The CFR Style coupling consist of 1 flex hub, 1 rigid hub, one sleeve, a single accessory kit consisting of seals and snap rings.
Attributes
Very simple and economical sort of gear coupling
All steel sleves and hubs
Reinforced rubber seals with snap rings to hold lubricant in place
Offered as vertical and horizontal couplings
Wide number of specific variations for instance full-flex, flex-rigid mill motor
Normal configurations are available of the shelf
Ordering Information and facts
Application: Driver and Driven.
Sort and dimension of coupling, horizontal, vertical etc.
Energy: Motor horspower or torque necessity.
Speed: Motor RPM or Driven RPM.
Distance between shaft ends (BSE).
Shaft sizes.
C and CFR Type Couplings
Ordering Data
Puller Holes are normal on sizes 4 via twelve.
Puller Holes can be found for sizes 7/8 as a result of 3.five at an extra charge.
The BSE (distance Concerning Shaft Ends) may vary among G and G1.
Interference bores without set screws are conventional unless otherwise specified.
Inch bores and keyway tolerances conform to ANSI / AGMA 9002-B04.
For metric bores and keyway tolerances, seek the advice of Engineering Section.
More substantial sizes are available, please seek advice from Technical Help.