Electrical power UNITS FOR LIFT TABLE 1
Common Description
This power unit is designed exclusively for your little lift table,Consisting of substantial stress gear pump, AC motor, multi-functional manifold, valves, tank, and so on. This electrical power unit is broadly utilized within the marketplace of logistic units which include minifork lift, scissors lift and ariel operating platforms. The lower-ing motion is managed through the solenoid valve using the pace managed by the adjustable needle valve.
Electrical power UNITS FOR LIFT TABLE two
Common Description
This energy unit is created solely for the medium lift table, Consisting of highly effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The lowering motion is actived by the solenoid valve and the pace controlled from the adjustable needle valve. When the lift rises to a substantial positoin, but the electrical power provide is lower, the lowering motion is managed from the guide override perform.
Energy UNITS FOR LIFT TABLE 3
General Description
This electrical power unit is made solely for the huge lift table, Consisting of highly effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing movement is actived by the solenoid valve plus the pace controlled by a stress compensated movement handle valve.
Power UNITS FOR LIFT TABLE 4
Standard Description
This power unit is designed exclusively for your massive lift table, Consisting of really effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering movement is actived from the solenoid valve and also the velocity controlled from the adjustable needle valve. Once the lift rises to a higher positoin, but the power provide is lower, the decreasing motion is managed through the guide override function.
Specific Notes
1. This energy unit is of S3 duty cycle, which may only operate intermittently and repeatedly, i.e. one minute on and 9 minutes off.
two. Clean every one of the hydraulic components concerned just before installation of the electrical power unit.
three. Viscosity on the oil shoud be 15~46 cst,which should also be clean and cost-free of impurities.N46 hydraulic oil is encouraged.
four. Oil changing is needed immediately after the first 100 operation hrs,afterwards as soon as each 3000 hrs.
5. The electrical power unit shown is created to be mounted vertically.